Garmin Support Center is where you will find answers to frequently asked questions and resources to help with all of your Garmin products. Therefore, an installation that meets the requirements for ATC transponders also meets this requirement. GTX /D Installation Manual Page B Rev. U Page 83For ATC transponder-based ADS-B transmit The IDENT key is available to the systems, the SPI capability needs to be pilot on the GTX GTX Installation Manual Page Revision G 1. GENERAL DESCRIPTION Introduction This manual presents the mechanical, and electrical installation requirements for the GTX Mode S Transponder and GTX D Diversity Mode S Transponder. Throughout this manual, the term GTX applies to both transponders unless otherwise stated.
meters, less than or equal to meters, less than or equal to meters, less than or equal to meters, less than or equal to meters, or more then meters. Enter the aircraft’s minimum width category. GTX /D Installation Manual Page Garmin Support Center is where you will find answers to frequently asked questions and resources to help with all of your Garmin products. Do not overtighten the screw. 5. To remove the unit from the rack, turn the 3/32” Allen wrench counterclockwise until it disengages from the rack. Figure GTX Unit Rack () GTX Installation Manual Page Page 22 This page intentionally left blank Page GTX Installation Manual Revision G
Page 9Entering a Flight ID Number When configured for FLT ID PWR-UP ENTRY at installation, the flight crew must enter the Page 10 GTX Mode S Transponder. Information Manuals for Mode A/C/S Aircraft transponder from Garmin. Installation Guide for models: GTX, GTX, GTX or GTX transponders. The GTX ss options are normally set at time of installation. To request any changes of the GTX parameters, contact your authorized Garmin Aviation.
0コメント